Installation
How do I turn off power to my HVAC?
Look for a switch located on or near your furnace. Location of the switch varies, so check the sides, rear or even in the rafters if the switch is not immediately visible. The switch will look like a standard light switch and should be flipped to the “off” position.
If you are unable to reach your furnace or air handler, or if you were unable to find the power switch, go to the main fuse box or circuit breaker and open the panel door. Inside, there will be several circuit breakers that should be labeled with the locations that each breaker feeds. Turn off the breaker for your HVAC equipment. If the breakers are not labeled, you may need to test each breaker to identify the corresponding areas of your home.
In either case, we suggest you verify that power has been turned off before proceeding with installation of your thermostat.
How do I verify the power is off?
On your existing thermostat, set the fan option to “ON”, then hold your hand over a vent. You should not feel air blowing from the vent. If you’re unsure if air is blowing, you can simply place a piece of paper over the vent register and see if the paper blows around.
In either case, if air is blowing from the vent, the equipment was not turned off properly. Please verify that the furnace switch is in the off position or that the correct breaker was switch off before proceeding.
Turning off the power of heating and cooling equipment
A how-to guide to turning off power to your heating and cooling equipment before you install your new Sensi thermostats.
Reach out to us
Our customer support is available 7 days a week.
